You’re ready to fly your drone, but it won’t connect to the controller. Try changing out the batteries and connecting again, and if that doesn’t work, make sure you’re using the right type of batteries for your drone. ![]() The most common reason a drone might not connect to the controller is because the battery is dead. ![]() Why Won’t My Drone Connect To The Controller? You should see a message on your display indicating that it is connected. If you are connecting via WiFi, make sure that both devices are powered on and connected to WiFi networks with no password needed (this is important!). Make sure that both devices are powered on and connected to WiFi. If you are using a cable, plug one end into your drone and the other end into your phone or tablet. To connect your device to the controller, you’ll need to press a button on the controller. Using A Button On The Controller, Connect It To Your Device It’s important to remember that once a connection has been established between your smartphone or tablet and your drone, they need to remain close together in order for communication between them to continue working properly. If you’re using an app to control the drone, check that it is connected to the correct device (and if necessary, turn on Bluetooth). If you’re using a remote control, make sure that it’s in range of the drone. Turn On The Controller, Then Turn On The Drone If you’re connecting via Bluetooth, select “OK” when prompted to accept pairing requests from other devices (this is required before proceeding). Press the power button on the top of the controller and wait for it to turn on, or press the power button on your mobile device and wait for it to turn on, then tap connect when asked if you want to connect via Bluetooth or WiFi. Connect The Controller To Your DeviceĬonnect the controller to your device using a cable or by turning on WiFi on your phone. If it does not turn green after 5 seconds, press and hold down the reset button on top of your controller until you hear a single beep sound from it (approximately 1 second). Turn on your controller by pressing and holding down the power button for 5 seconds, until you hear a beep sound from the controller and LED light turns green. ![]() Wait for 2 minutes for the Firmware to initialize. Turn on the drone by pressing the power button for 5 seconds. If they are not, charge the battery by plugging it into a power source and allow it to charge for 15 minutes before continuing with this process. To check if your battery is fully charged, you will need to look at the lights on your controller (usually three lights) and check that all of them are lit up green. Here are instructions on how to do that: step 1. When you’re ready to take your drone out for a flight, you’ll need to make sure it’s connected to its controller. While holding down that button, connect your smartphone or tablet to your drone’s Wi-Fi network. To connect your drone to the controller, you need to turn on the controller, then press and hold the button on the side of the controller until you hear a beep or see lights flash. Step By Step Instructions To Connect Drone To Controller ![]() How Do I Connect Drone To Dji Controller?.How Do I Connect My Mini Drone To My Controller?.Why Won’t My Drone Connect To My Controller?.Frequently Asked Questions (how To Connect Drone To Controller).Why Won’t My Drone Connect To The Controller?.step By Step Instructions To Connect Drone To Controller.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |